Hillsdale Furniture VANITY DUTTON 50941 Instructions De Montage

HILLSDALE
FURNITURE, LLC.
Examine all packaging material for small parts that may have come loose during shipment. Periodic checks are recommended to insure
that all components are in proper position, tight and free from damage. Keep this assembly instruction for future reference. Adult assembly
is required. Customer Service Phone Number: 502-562-0000
HARDWARE LIST
A (4) 1/4" x 5/8" Allen Bolts
B (4) 1/4" x 1/2" Allen Bolts
C (8) 1/4" x 3/4" Allen Bolts
D (4) Large Washers
E (8) Small Washers
F (8) Spring Washers
G (1) 1/4" Allen Wrench
PARTS LIST
H (1) Back Panel
I (1) Seat Base
J (1) Cushion
K (2) Front Legs
L (1) Cross Frame
B
D
C
CARE & MAINTENANCE: The touch of a soft cloth is all the maintenance the finish will ever need. Please do not use harsh or abrasive cleaners for polishing,
as they may cause damage to the finish. Periodic checks are recommended to make sure that all bolts, screws and nuts are securely tightened.
DUTTON VANITY STOOL
H
J
D
E
C
F
A
E F A
B
L
E
K
F
C
B
Model #50941
PART QTY HARDWARE
A 4
C 8
E 8
G 1
STEP 1
Begin assembly by attaching the Seat Base (I) to the Back
Panel (H) by aligning the open holes and securing with 4
Long Allen Bolts (A), 4 Spring Washers (F), & 4 Small
I
E F A
D
D
C
E
C
F
C
B
K
PART QTY
B 4
D 4
F 8
Washers (E) to secure each in place. Do
not tighten all bolts for this step.
STEP 2
Next, attach each Front Leg (K) to the
bottom of the Seat Base (I) using 2 Allen
Bolts (C), 2 Spring Washers (F), & 2 Small
Washers (E) to secure each in place. Do
not tighten all bolts for this step.
STEP 3
Next, attach Cross Brace (L)
to each Front Leg (K) and rear
legs on Back Panel (H) using
1 Allen Bolt (B). Tighten all
bolts from steps 1-3 using Allen
Wrench (G) provided.
STEP 4
Finally, attach Seat Cushion
(J) to Stool Seat Base (I), using
4 Allen Bolts (C) and 4 Large
Washers (D). Tighten all bolts.
Assembly of your stool is now
complete. Please keep this
Assembly Instruction Sheet for
any future use or information.
Date: 08-03-2011
Page 1 of 1
HARDWARE