BERNSTEIN ITR 10 Mode D'emploi/Certificat De Garantie page 3

IMPORTANT SAFETY INSTRUCTIONS
· Please read and keep these instructions.
· This device is only intended for use with 230 V/50 Hz AC voltage.
Only operate the device in the specified temperature range of 0°C to 40°C.
·
Make sure there is sufficient ventilation for the device. There must be a minimum gap of 10
·
cm between objects to the side, to the rear and above the device.
Do not expose the device and the remote control to water or moisture.
·
The unit shall not be exposed to dripping or splashing. No objects filled with liquids, such
·
as vases, shall be placed on the unit.
In the event of contact with moisture or liquids remove the mains adapter immediately.
·
Only clean the device using a dry cloth.
·
Do not use any cleaning agents or chemical solvents when cleaning, as these could
·
damage the surface of the device.
Never open the device.
·
The device should not continue to be operated if there is visible damage to the mains
·
cable. A damaged cable should not be repaired, but must be replaced.
Do not connect or remove the mains cable with damp hands.
·
Always refer to a qualified specialist for any maintenance or repair work.
·
If the device is not going to be used for a prolonged period, switch it off by using the power
·
switch.
Unplug the unit during lighting storms.
·
Do not block any of the ventilation openings (e. g. by curtains, newspaper, etc.) in order to
·
guarantee adequate ventilation of the unit.
Do not install near any heat sources such as radiators, heat registers, stoves, or other
·
apparatus that produce heat.
Warning:
Do not open! Risk of electric shock.
To reduce the risk of fire or electric shock do not expose
this unit to rain or moisture.
This symbol warns the user that high voltage is used within
the device which can result in electric shock.
This symbol makes the user aware that there are important
notes in the enclosed instruction manual which must be
observed.