Radio Operation - Sangean DT-220 Mode D'emploi

Alarm time (Standby) set
To set the alarm only when radio is off.
Press Standby button , display alarm icon
6
last alarm time will appear. Press Standby button
again for more than 2 seconds until display alarm
icon
also last alarm time flashes. Press tuning UP/DOWN
button to set the alarm hour then press Standby
button again to set the minute. Press Standby
button again to finalize Alarm time set. Display will
be back to real time after alarm time set is done.
Alarm icon will appear on the display indicating in
Alarm (standby) status.
When alarm is on, press any push buttons to switch
it off and back to Alarm status. The alarm buzzer will
last for 3 minutes before it is switched off.

Radio operation

Tuning the station
Turn on the radio by pressing POWER button
select desired radio band by pressing BAND button
. Use Tuning UP/DOWN button to tune in stations.
For an automatic station search , press
button until frequency display starts advancing on it
own. Then release the button.
The tuning function will stop automatically when a
power signal from a station is found . The search
can be broken off by pressing the button for the
opposite direction.
also
GB
,
7
11
or
5