Panasonic KX-HNS107C Mode D'emploi page 14

Setup
1
Make sure that the front cover and
the mounting adaptor are firmly
attached to the sensor.
2
Affix the double-sided tape to the
mounting adaptor.
R Make sure the tape covers the
3
Attach the sensor to the inside of
the garage door.
R Make sure the mounting
R Press firmly to ensure solid
14
HNS107C_(en_en)_0212_ver.011.pdf
screw holes on the mounting
adaptor.
adaptor release lever is facing
down when the garage door is
closed.
adhesion to the installation
surface.
For assistance, visit www.panasonic.ca/english/support
14
Removing when secured with
double-sided tape
1
Tie a piece of thread to two sticks,
screwdrivers, etc.
2
Pull the thread tight and use it to
cut the double-sided tape, and
then remove any excess tape (A).
A
2016/02/12 9:35:26