Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 2 screws BHc 5×15 (big head)
- 2 plastic washers Ø5
Fitting instructions
- Remove the original chain guard and retain the screws.
- Remove the brake hose bracket.
- Position the two threaded fasteners on the rear hugger (see photo).
- Assemble the Ermax chain guard and hugger using the 5×15 screws and the plastic washers.
- Position the complete unit on the scooter and attach the chain guard using the original screws and the Ø6
plastic washers which have been provided. Fix the front part of the hugger and position the brake hose
bracket as shown in the photo.
Location of brake hose
bracket
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we made with original
tyres and whose dimensions correspond to these ones engraved on tyre.
* Harden the rear shock absorber while drivings with load or on dented roads.
ERMAX REAR HUGGER AND CHAIN GUARD ADAPTABLE ON
- 2 threaded fasteners M5
- 4 plastic washers Ø6
« CAUTION »
FITTING INSTRUCTIONS
APRILIA SRV 850 2012 → ∞
GILERA GP 800 2008 → ∞
Fitting estimated time : 30 mn
Location of threaded
fasteners
Publicité
