ifrogz impulse wireless Instructions page 2

impulse wireless instructions
1
Introduction
The Impulse Wireless Earbuds feature advanced audio technology that
brings your music to life. Here's how to get the most out of them.
To download this manual, visit www.zagg.to/manuals.
2
Wireless Hub
Your Impulse Wireless Earbuds feature a wireless hub that houses all the
music and call controls for easy access. When you're not using your earbuds,
the magnetic Storage Clip™ makes cable management easy; simply wrap
the earbud cables around the wireless hub and secure in place with the
Storage Clip. Whether they're in your ears or in your pocket, the Impulse
Wireless Earbuds were made to move. Below is a quick reference for how to
use the wireless hub:
Button Functions:
Raised bump button (Up button)
- Quick press – Volume up
- Long press – Track next song
Middle button (Center button)
- Quick press – Play/Pause/Answer call/End call
- Medium press – Voice control (Siri
- Long press – Power on/Power off/Deny call
Recessed groove button (Down button)
- Quick press – Volume down
- Long press – Track previous song
3
Reflective Acoustics
Your Impulse Wireless Earbuds are engineered with Reflective Acoustics,
an advanced audio technology that formulates sound based on the
fundamentals of human hearing. The high-quality driver reflects sound off
a micro acoustic panel to magnify sound waves. Sound is then delivered to
you with accurate tonal balance, even dispersion, natural clarity, and a rich,
dynamic range.
4
Power and Pair
1. Press and hold the Power button until the LED flashes red and blue.
2. Ensure your device's Bluetooth® connection is on and select "IFROGZ
Impulse". Complete any additional pairing steps based on your device.
The LED will flash blue every five seconds while the earbuds are on
and paired.
3. To turn your earbuds off, press and hold the Power button for six
seconds. The LED will flash red until they are powered off.
4. The next time you turn on the earbuds they will automatically connect
to your device.
NOTE: If you are pairing with a new device, with your earbuds off, press
and hold the Power button for five seconds until the light flashes red
and blue, indicating pairing mode.
and Android
®
Recessed
groove button
™
Raised
bump button
Middle
button
)
®