tibelec DT-930 Notice D'utilisation page 13

1. Connect the black probe to terminal COM and the red probe to terminal VΩ
2. Set the function switch to the
3. Connect the test plungers to the circuit and read the value displayed on screen once it has stabilised.
WARNING: ENSURE RESPECTING POLARITIES
1. Connect the black probe to terminal COM and the red probe to terminal VΩ
2. Set the function switch to the
3. Connect the test plungers to the circuit and read the value displayed on screen once it has stabilised.
When you measure a DC voltage, the screen shows the polarity of the red probe.
WARNING: ENSURE RESPECTING POLARITIES
1. Connect the black probe to terminal COM and the red probe to terminal 10A
2. Set the function switch to the
3. Connect the test plungers to the circuit and read the value displayed on screen once it has stabilised.
1. Connect the black probe to terminal COM and the red probe to terminal 10A
2. Set the function switch to the
3. Connect the test plungers to the circuit and read the value displayed on screen once it has stabilised.
1. Connect the black probe to terminal COM and the red probe to terminal VΩ
2. Set the function switch to the
3. Connect the test plungers to the circuit and read the value displayed on screen once it has stabilised.
V
~
V
~
10A
10A
Ω
CAP Hz
CAP Hz
CAP Hz
13