User Interface/Controls - Black & Decker BD-35-WH Mode D'emploi

pH Total Free
Dissolved CO2
Solid (TDS)
6.5 Up to Up to
- 500 500
8.5 mg/L mg/L

10. User Interface/Controls

Power
• Turn the knob clockwise, LOW/MID/HIGH the Led light will
turn on
• Turn the knob counterclockwise 0, the Led light will turn off
Starting the system for the first time
1. Turn the knob clockwise, to activate the heater.
2. Turn the knob clockwise to increase the temperature or
counterclockwise to decrease the temperature.
model
BD-35-WH
BD-70-WH
BD-13-WH
Freezing Temperatures
If the ambient temperature falls below 32°F (0°C), protect the heater from potential damage. Power
off the unit using the dedicated circuit breaker on the main electrical panel. Open a faucet slightly
to cause water to flow continuously through the device at a very low rate, without heating. Restore
power to the unit when temperature condition is normal.
If the water inside the heater freezes, it can cause damage that is not covered by warranty. If
you suspect water has frozen within the unit, do not turn it on until you are sure the frozen water
has melted, and there are no leaks in the unit. It is recommended to contact a qualified electrician
or the manufacturer for service in this situation.
Chart for Recommended Water Quality levels
Total Aluminum Chloride Copper
Hardness
Up to Up to
200 0.2
mg/L mg/L
Position Total kW
High
Medium
Low
High
Medium
Low
High
Medium
Low
Iron
Up to Up to Up to
250 1.0 0.3
mg/L mg/L mg/L
3.5
2.3
1.2
7
4
3
13
8.66
4.33
EN
Manganese Zinc
Up to Up
Inline 800
0.05 to 5
mg/L mg/L
13