Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

IMPORTANT INSTRUCTIONS -
Advantage
Professional Series
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN
THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY
INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY
When using electrical appliances, basic precautions should always
be followed to reduce the risk of fire, electric shock and injury to
WARNING:
ELECTRIC SHOCK AND INJURY TO PERSON, OBSERVE THE
FOLLOWING:
a)
Use this unit only in the manner intended by the manufacturer.If you have questions,
contact the manufacturer.
b)
Before servicing or cleaning the unit, switch power off at service panel and lock the
service disconnecting means to prevent power from being switched on accidentally.
When the service disconnecting means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
WARNING:
ELECTRIC SHOCK AND INJURY TO PERSON, OBSERVE THE
FOLLOWING:
a)
Installation work and electrical wiring must be done by qualified person(s) in accordance
with all applicable codes and standards, including fire-related construction.
b)
Sufficient air is needed for proper combustion and exhausting of gases through the
flue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating
equipment manufacturer's guideline and safety standards such as those published by
the National Fire Protection Association (NFPA) and the American Society for Heating,
Refrigeration, and Air Conditioning Engineers (ASHRAE), and the local code authorities.
c)
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities.
CAUTION:
USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS AND VAPORS.
CAUTION:
PROPERLY EXHAUST AIR, BE SURE TO DUCT AIR OUTSIDE - DO NOT
VENT EXHAUST AIR INTO SPACES WITHIN WALLS OR CEILINGS OR INTO ATTICS, CRAWL
SPACES, OR GARAGES.
d)
Ducted fans must always be vented to the outdoors.
e)
This unit must be grounded.
f)
To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall
spray, construction dust, etc. off power unit.
g)
Read all instructions before installing or using range hood.
A111597016 Rev. J 1-16
OPERATING MANUAL
AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
person, including the following:
TO REDUCE THE RISK OF FIRE,
TO REDUCE THE RISK OF FIRE,
FOR GENERAL VENTILATING USE ONLY. DO NOT
TO REDUCE THE RISK OF FIRE AND TO
SAVE THESE INSTRUCTIONS
WARNING:
SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED
CONTROL DEVICE.
WARNING:
GREASE FIRE:
a)
Never leave surface units unattended at high settings. Boil overs cause smoking
and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
b)
Always turn hood ON when cooking at high heat or when flambéing food (ie. Crepes
Suzette, Cherries Jubilee, Peppercorn Beef Flambé).
c)
Clean ventilating fans frequently. Grease should not be allowed to accumulate on
fan filter.
d)
Use proper pan size. Always use cookware appropriate for the size of the surface
element.
WARNING:
IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING:
a)
SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off
burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately,
EVACUATE AND CALL THE FIRE DEPARTMENT.
b)
NEVER PICK UP A FLAMING PAN - You may be burned.
c)
DO NOT USE WATER, including wet dishcloths or towels -
a violent steam explosion will result.
d)
Use an extinguisher ONLY if:
I.
You know you have a Class ABC extinguisher, and you already know how to
operate it.
II.
The fire is small and contained in the area where it started.
III.
The fire department is being called.
IV.
You can fight the fire with your back to an exit.
WARNING:
METAL DUCTWORK.
www.airkinglimited.com
Range Hood
TO REDUCE THE RISK OF FIRE, ELECTRIC
TO REDUCE THE RISK OF A RANGE TOP
TO REDUCE THE RISK OF INJURY TO PERSONS
TO REDUCE THE RISK OF FIRE, USE ONLY
1 of 16

Publicité

loading

Sommaire des Matières pour AirKing Advantage Professional Serie

  • Page 1 IMPORTANT INSTRUCTIONS - OPERATING MANUAL Advantage Range Hood Professional Series READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
  • Page 2 INSTALLATION INSTRUCTIONS NOTE: When determining the height of the canopy from the cooking surface, be sure to take into consideration items such as back splashes with shelves and other accessories that might CAUTION: need more clearance under the canopy. MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE STARTING INSTALLATION.
  • Page 3 SECTION 4 Installing Backsplash Wood Mounting If an optional BS Series backsplash will be utilized, this must be installed before the hood Screw canopy because the hood canopy will cover the backsplash mounting screws. Refer to Strip the instructions included with the backsplash for installation. SECTION 5 Wall Anchor Hood...
  • Page 4 NOTE: If the recommended, optional BS Series backsplash is being installed, use the template Outlet Adapter to locate and drill the appropriate holes for mounting. The back splash must be installed before the hood canopy because the hood canopy will cover the backsplash mounting screws. Refer to the instructions included with the backsplash for complete installation instructions.
  • Page 5 SECTION 12 SECTION 8 Maintenance Installing the Blower CAUTION: Refer to the instructions included with the blower for installation. MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE SERVICING THE UNIT. SECTION 9 Grease Filters Installing the Optional Soffits Included with your range hood are grease filters along with a grease trough that should be Refer to the instructions included with the specific soffit(s) you have chosen for installation.
  • Page 6 Troubleshooting Guide Trouble Probable Cause Suggested Remedy 1. Hood does not operate when the switch is on. A fuse may be blown or a circuit tripped. Replace fuse or reset circuit breaker. Wiring is not connected properly. Turn off power to unit. Check that all wires are connected. 2.
  • Page 7 REPLACEMENT PARTS DIAGRAM - 18" MODELS REPLACEMENT PARTS DIAGRAM - 18" MODELS Qty. Description Replacement Part # Qty. Description Replacement Part # Wire Box 5S1138002 Sub Wire Harness without Heat Lamp 5S1138007 Main Wire 5S1138003 Sub Wire Harness with Heat Lamp 5S1138018 Cabinet - 30"...
  • Page 8 REPLACEMENT PARTS DIAGRAM - 10" MODELS Qty. Description Replacement Part # Qty. Description Replacement Part # Wire Box 5S1138002 Internal Panel 30" models 5S1138430 Main Wire 5S1138003 Internal Panel 36" models 5S1138440 Cabinet - 30" models 5S1138030 Sub Wire Harness without Heat Lamp 5S1138007 Cabinet - 36"...
  • Page 9 INSTRUCTIONS IMPORTANTES – MODE D’EMPLOI Séries Professionnelles Hotte de Cuisine Advantage LIRE ET CONSERVER CES INSTRUCTIONS LIRE SOIGNEUSEMENT AVANT DE TENTER D’ASSEMBLER, INSTALLER, OPÉRER OU DE RÉPARER LE PRODUIT DÉCRIT. PROTÉGEZ VOUS-MÊME ET LES AUTRES EN OBSERVANT TOUTE L’INFORMATION DE SÉCURITÉ. FAILLIR À SE CONFORMER AUX INSTRUCTIONS PEUT RÉSULTER EN BLESSURE PERSONNELLE GRAVE ET/OU EN DOMMAGE À...
  • Page 10 INSTRUCTIONS D’INSTALLATION REMARQUE : Lorsque vous déterminez la hauteur entre le couvert et la surface de cuisson, assurez-vous de prendre en considération les articles tels que dosseret avec tablettes et autres AVERTISSEMENT : accessoires qui pourraient avoir besoin d’un plus grand dégagement sous le couvert. VOUS ASSURER QUE L’ALIMENTATION EST COUPÉE AU PANNEAU DE SERVICE AVANT DE COMMENCER L’INSTALLATION.
  • Page 11 SECTION 4 Installation du clapet anti-retour Bande de Si un clapet anti-retour optionnel de Série BS sera utilisé, celui-ci doit être installé avant montage le couvert de la hotte parce que le couvert de la hotte couvrira les vis de montage du en bois clapet anti-retour.
  • Page 12 REMARQUE : Si le dosseret facultatif recommandé de la série BS est installé, il doit être Adaptateur de installé avant la verrière de la hotte parce que la verrière de la hotte couvrira les vis de sortie support du dosseret. Référez-vous aux instructions incluses avec le dosseret pour des instructions d’installation complètes.
  • Page 13 SECTION 8 Thermostat Votre hotte est équipé d’un thermostat qui allumera automatiquement le hotte quand la Installation de la soufflante température dépasse un point déterminé. Une fois que la température s’abaisse, le thermostat Référez-vous aux instructions incluses avec le ventilateur pour l’installation. éteindra le hotte.
  • Page 14 Guide de dépannage Trouble Cause possible Solution suggérée 1. La hotte ne fonctionne pas lorsque 1a. Un fusible peut être grillé ou un disjoncteur peut être déclenché. 1a. Remplacer le fusible ou réinitialiser le disjoncteur. l’interrupteur est à EN (ON). 1b.
  • Page 15 TABLEAU DES PIÈCES DE RECHANGE - MODÈLES DE 18 PO # de pièce # de pièce Qté. Description de remplacement Qté. Description de remplacement Boîte de filage 5S1138002 Harnais de sous-câblage sans 5S1138007 lampe chauffante Fil principal 5S1138003 Harnais de sous-câblage avec 5S1138018 Armoire –...
  • Page 16 TABLEAU DES PIÈCES DE RECHANGE - MODÈLES DE 10 PO # de pièce # de pièce Qté. Description de remplacement Qté. Description de remplacement Boîte de filage 5S1138002 Boutons 5S1142011 Fil principal 5S1138003 Modèles de 30 po à panneau interne 5S1138430 Armoire –...