Intended Use; Predictable Misuse / Improper Handling; Residual Risks; Technical Data - hawa Powerman Junior Mode D'emploi

Operating instructions Powerman Junior

3.1 Intended Use

The Hand pump Compact has been developed for the rapid punching of round and shaped holes in steel, stainless steel, and aluminum sheets.
Under certain conditions, also some plastics can be cut (soft plastics with sharp cutting heads). In such a case, prior trials are required.
Requirement: Based on the design using a bolt, it is required to pre-drill a hole in the work piece.
The use of the hand pump compact must follow along with the guidelines of this manual.
Each and every inappropriate usage are considered unauthorized handling and therefore outside of the manufacturer's limit of liability.
Application ranges
• Mounting plates
• Junction boxes
• Enclosures
• Cable ducts ec.

3.2 Predictable misuse / improper handling

Predictable misuse / improper handling:
• Outdoor use
• Use with blunt tooling
• Incorrectly executed repairs
• Non-intended use
• Punch, die and bolt must fit (ø of die and punch have to fit)

3.3 Residual risks

Not all risks could be avoided structurally without confinement of its intended use. The residual risks of the Hand pump Compact have been analyzed
with a risk assessment.
Possible residual risks that cannot be avoided structurally could be:
• Bruises or cutting of limbs through disregard of this instruction manual
• Bursting of a hydraulic hose
• Slipping on oil through hydraulic leak
• Cutting injuries through tools or sharp sheet metal
• Pinching of fingers during the pumping
Residual risks can be avoided by doing the following:
• Vigilant working
• Paying attention to all notes in this manual
• Following the general safety stipulations / regulations

4. Technical data

• Bolt size: 9,5 mm/ 0.37 inch
• Pressure max. 500 bar
• Oil filling: 0.19 l
• Cylinder stroke: 12 mm
Usable for:
• Round punches up to Ø 50,5 mm
• Square punches up to 25,4 mm
• Rectangular punches up to 35 mm diagonale
For punching sheets of:
• Steel up to 2 mm
• Stainless steel up to 1,5 mm
• Aluminium up to 3 mm

5. Scope of delivery

• Pump complete
• 1 bolts ø 3,8"
• according to hand pump without punch tools
• 1 round punch each M12, M16, M20 and M25 (ø 12,7; ø 16,3; ø 20,4 and ø 25,4 mm)
7