Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 11: LUBRICATING & PLACING THE SWEEP SEALS
• Locate the sweep seals (rubber weather strips) on
the rails. Open the provided protectant wipe that you
removed from the Top cover in step 6 (find it adhered
to the underside of the top cover). Wipe the underside
of the sweep seal and the top of the wear strip.
• Extend the cover to the tailgate. Use an Allen wrench
if needed to carefully draw out the sweep seal,
(seal should be angled outwards toward the cover – not rolled in toward the bed rail). (Fig. 11A)
• Proper care and placement of the sweep seal will help with smooth operation of the cover. Alcohol,
petroleum based or silicon-based UV Protectants such as Armor-All® should be avoided and ARE NOT
recommended for our covers.
HARDWARE
HARDWARE
USED:
USED:
THE ELECTRONICS BOX HAS BEEN PRE-MOUNTED TO THE
INSIDE OF THE CANISTER.
• Connect the battery wire harness into the 2-wire plug at the end of the canister.
Connect the Wire Prong labeled "Power". Also connect the optional manual switch
harness, if installed at this time.
2-Button Remote
Key Fob x2
• Attach the
manufacturers suggested connection points at this time.
• Remove any snow or foreign matter
before operating the unit.
• Unit is now ready to operate.
• Press the Open button to open the cover
Part #BL232
and press the Close button to shut the cover.
Pinch hazard
STEP 13: COVER RELEASE INSTRUCTIONS
FIG. 14A
If power is lost to the UltraGroove Electric unit, or the electric drive system fails to operate and you have to use
the cover right away, you can do the following to open or close the cover:
1. You will need to gain access to the release handle
located on the driver side of the canister at the front
of the truck bed. Once you have access to it, pull the
handle out away from the canister and then pull out the
handle kickstand behind it.
2. Settle the kickstand into the notch on the handle to
hold the handle in place.
3. Now, you should be able to push or pull the paneled
cover manually open or closed.
NOTE: The cover will not lock unless you disengage the
kickstand and lower the release handle. With the handle
released, the cover will move a short distance and the cover will then
lock itself in place. (Cover may not lock tightly against tailgate.) This process will allow
you to use the cover until power is restored. It is not meant for extended or permanent use.
STEP 12: CONNECTING THE ELECTRONICS
Notch
Feature
Foam
Washer
RED
(positive) and BLACK (negative) wires to the battery or the truck
Drain Fitting
Drain
Tube
Rail
FIG. 11A
FIG. 13A
Sweep Seal
Ribbed Cover
Solid Wear Strip
13
Publicité
Chapitres
Table des Matières
