Publicité
Les langues disponibles
Les langues disponibles
Figure 3
Iron Free Water
Iron Free Soft Water
Out
Drain
NOTE: Before starting installation, read Page 8, Plumbing System Clean-Up, for instructions on some procedures that may
need to be performed first.
Installation of the Air Pump with Flow Control Switch (Mascontrol) as Power Source
1. Used when pressure switch and air pump are in alternate locations. Also used on constant pressure or variable speed
pump systems.
2. Mascontrol acts as a flow control detecting flow.
3. Connect the air pump to the Mascontrol receptacle. See Mascontrol manual for wiring diagram.
4. All government codes and regulations governing the installation of these devices must be observed. Check your local
electrical codes or contact a qualified electrician.
Figure 4
1. Shut off all water at main supply. On a private well system turn off power to pump and drain pressure tank. Make certain
pressure is relieved from complete system by opening nearest faucet to drain system. Shut off fuel supply to water heater.
Media Installation (When Necessary)
•
Remove the valve from the mineral tank.
•
Temporarily plug the open end of the riser tube to ensure that no resin or gravel falls down into the distribution.
•
Fill mineral tank one quarter full of water to protect distribution during gravel installation.
•
Slowly and carefully add the gravel support bed and the softener media leveling each layer as it is placed into the tank.
•
Unplug the riser tube, carefully position the valve over it and turn the valve into the threads in the fiberglass tank,
tightening securely into tank. Note: Ensure that the internal O-ring in the valve fits securely over the riser tube. Silicone
grease (#13691) or other food grade lubricant may be applied to the O-ring to ease installation of the riser tube. DO
NOT use petroleum based lubricants as they will cause swelling of 0-rings and seals.
•
The softener is now charged with softening resin.
•
It is recommended that the softener tank now be completely filled with water (SLOWLY) to soak the resin before startup.
This will allow the media to absorb water as well as help displace any trapped air. This will reduce the chance of
backwashing resin out during startup.
Air Release Valve
In
Drain
Pressure
Tank
Softener
Iron Filter
Pressure Switch
Installation Instructions
Outdoor
Raw
Water
To 110V
Outlet
Raw Well Water
Meter
Hydro-
Solenoid Valve
charger
5
Publicité
