Jumbo URC-151 Mode D'emploi

JUMBO Universal remote
URC-151
User guide
This universal remote controls up to eight electronic components
and makes juggling remote controls a thing of the past. You can
program this remote to operate most models of most brands of
infrared, remote-controlled components manufactured after 1990.
(See enclosed Code List for a complete list of brands).
This jumbo-sized remote is easy to use, easy to program and
almost impossible to lose.
Battery installation and information
Your universal remote requires two AA alkaline batteries (not
included).
1. Remove the battery compartment cover.
2. Insert the batteries, matching the polarity marks (+)(-) inside
the battery compartment.
3. Press and push the battery cover back into place.
Note: Reprogramming may be required after batteries are
replaced.
Key descriptions
: Buttons to control DVD /VCR.
REC
0-9 (Number Keys): operate the same as number keys on your
original remote and are used to enter component codes when
programming the remote control with Direct Entry method.
TV - VCR: in TV mode, switches between the signal coming
from a satellite receiver or cable box and an off-air antenna.
In VCR mode, switches between the signal coming from a VCR
and a TV.
CH + and CH - : goes to the next highest or lowest channel
number in the component channel list, respectively, except for
DVD's. In DVD's the CH +/- goes to the
chapter. Additionally, when you are using the remote with
On-screen menus, the CH keys act as
DOWN ARROW keys.
CODE SEARCH: use to program the remote.
ENTER: use with Manual Code Search method to accept code
(See code search). Also, some brands require you to press the
ENTER key after you enter a channel number. In some menu
systems, you must press ENTER
MENU: accesses DVD disc menus when
programmed to operate a DVD player. Accesses menu systems
of some TVs, VCRs and satellite receivers.
: turns off the TV's volume.
: turns component ON/OFF.
GO BACK: switches back to previous channel - operates the
same as LAST CHANNEL GO BACK ,
on some brands of remote controls.
REC:
used with VCR to record programming. You must press
the REC key twice to start recording.
SLEEP: allows you to set a time to turn off your TV automatically.
(Refer to page 7 for how to set the sleep time).
VOL +/-: i ncreases or decreases the TV's volume level.
Additionally, when you are using the remote with On-screen
menus, the VOL keys act as
GUIDE: brings up the on-screen program guide if your device
has that feature.
: use to move through on-screen menu and
OK
UP DOWN LEFT RIGHT
guide for some TVs or DVDs.
INFO: shows the information or TV channel on screen if
available with your device. Press INFO again to remove on-
screen display (some TVs).
NEXT / PREVIOUS
UP ARROW and
to select a highlighted item.
DVD key is
or RECALL key found
RIGHT and LEFT ARROW keys.
1