Publicité
Les langues disponibles
Les langues disponibles
4. PACKING LIST
1 piece
Mask body (including control cassette)
1 piece
Headband
1 piece
Operation manual
5. SPECIFICATION
Optical Class
Filter dimension
View area
Sensing
Light Shade
Dark Shades
Time from light to dark
Time from dark to light
(Delay)
6. METHOD OF OPERATION
•
Assemble the mask as shown in the construction and assembly scheme (see fig. 1 )
•
. The power of HORUS helmet is provided by solar cells with one lithium battery.
Turning on or off is automatic controlled by circuit. You can use this helmet at any time you need and
take it away after working without operating any key.
•
according to the technical requirement, the operator adjusts the darkness knob 5 in the direction
shown by the arrow to select the optimum darkness.
•
the lens to lighten after welding can be adjusted.
Turn to
: The time the lens lightens after welding is about 0.1 second depending upon welding
point temperature and shade setting. This setting is ideal for track welding or production welding with
short welds.
Turn to
: The time the lens lightens after welding is about 0.5 second depending upon welding
point temperature and shade set.
Turn to
: The time the lens lightens after welding is about 0.9 second depending upon welding
point temperature and shade setting. This setting is ideal for welding at high amperage where there is
an after glow from the weld.
•
to ambient light changes can be adjusted.
Turn to
: The photosensitivity changes to be lower. Suitable for high amperage welding and
welding in bright light conditions (lamp light or sun light).
Turn to
: The photosensitivity changes to be medium. Suitable for medium amperage welding
and welding in medium light conditions.
Turn to
: The photosensitivity changes to be higher. Suitable for low amperage welding and using
in poor light conditions. Suitable for using with steady arc process such as TIG welding.
If the helmet can be used normally, we suggest to use "HIGH" sensitivity.
•
The operator may adjust the headband adjusting button 1 3 and the segmental positioning plate 1 4 to
select an appropriate observing angle.
By pushing and turning the adjustment screw 1 2, the perimeter of the head band can be adjusted.
•
Turn shade adjusting knob anti-clockwise until you feel knob "click". You can now
grind with helmet. Remember to turn knob back when you want to weld again.
1 /1 /1 /2
1 1 0 x 90 x 9 mm
90 x 40 mm
2 sensors
#4
#9 - #1 3
0.1 msec (1 /1 0000 sec)
Slow: 0.9 sec
Medium: 0.5 sec
Fast: 0.1 sec
Striking the arc, the observing window darkens immediately. At this moment,
By moving the
. By moving the
Sensitivity
Grinding function
Power Supply
Auto power off
UV/IR protection
Operating temperature
Storage temperature
Standards
selector 1 0 on the rear of the cartridge, the time taken by
selector 9 on the rear of the cartridge, the sensitivity
3/1 6
Low, Medium, High
Yes, external
Solar cell + 1 x CR2450 Lithium
battery not replaceable.
Yes
up to DIN 1 5
-1 0°C ~ 65°C (1 4°F ~ 1 49°F )
-20°C ~ 80°C (-4°F ~ 1 76°F)
EN379 (Filter) EN1 75 (Helmet)
CE – ANSI Z87.1
EN
Publicité
