Remote Control Function - Leggett & Platt premium MODELS Prodigy 2.0 Queen Mode D'emploi

Press and hold to raise head to the
preprogrammed position. Head will
automatically lower to fl at after 15
*To program a position, adjust base to
desired position, press and hold the set
button until the massage motors and
underbed light turn on and off, then
press and hold the Snore button until
the massage motors turn on and off.
HEAD UP/DOWN BUTTON
Press and hold to raise or lower the head
PILLOW TILT UP/DOWN BUTTON
Press and hold to raise or lower the
pillow tilt section.
Press and hold to program M1, M2 and
HEAD MASSAGE UP/DOWN BUTTON
Press to increase or decrease massage
intensity. Massage has 3 speeds:
Low, medium and high. Massage will
automatically shut off after 15 minutes.
MASSAGE ON/OFF BUTTON
Press "on" to turn both massage motors
on. Press "off" to turn both massage
Press and hold to lower the base to the
PRESS & HOLD TO ONE TOUCH
Note: If using 2 remotes to operate 1 or more bases, both remotes must be set to the same "press & hold" or "press & touch" mode.
To change remote control functions from "press and hold" to "one touch" ("one touch" = press and release), simultaneously press
the HEAD MASSAGE DOWN and FOOT MASSAGE DOWN buttons for 5 seconds. The massage motor
and off confi rming the change. Your base is now set to "one touch."
When in "one touch" mode:
M1, M2, and Snore buttons
Press and release (one touch) button. Base will adjust to the programmed position. Press any other button to stop the base during movement.
Flat button
Press and release (one touch) button. Base will shut off massage motor, if active, and adjust base to level position. Press any other
button to stop the base during movement.
To revert back to factory settings, simultaneously press and hold the SET button and the FLAT button for 5 seconds. The massage
motor will turn on and off confi rming the change. Your base is now set to factory settings. Note: M1, M2, and Snore positions will
revert to factory preprogrammed positions.
12
Prodigy™ 2.0 Adjustable Base Owners Manual 99301584-c

REMOTE CONTROL FUNCTION

SNORE BUTTON
minutes.
section.
SET BUTTON
Snore presets.
motors off.
FLAT BUTTON
level position.
REMOTE CONTROL REQUIRES THREE (3) AAA SIZE BATTERIES (INCLUDED).
UNDERBED LIGHT BUTTON
Press to turn underbed light on. Press
again to turn underbed light off.
LOCK BUTTON
Press to lock remote control. Press again
to unlock remote control.
FOOT UP/DOWN BUTTON
Press and hold to raise or lower the foot
section.
M2 BUTTON
Press and hold to adjust base to the
programmed position.
*To program a position, adjust base to
desired position, press and hold the set
button until the massage motors and
underbed light turn on and off, then
press and hold the M2 button until the
massage motors turn on and off.
FOOT MASSAGE UP/DOWN BUTTON
Press to increase or decrease massage
intensity. Massage has 3 speeds:
Low, medium and high. Massage will
automatically shut off after 15 minutes.
NOTE
M1 BUTTON
Press and hold to adjust base to the
programmed position.
*To program a position, adjust base to
desired position, press and hold the set
button until the massage motors and
underbed light turn on and off, then
press and hold the M1 button until the
massage motors turn on and off.
will turn on
and underbed light