Efco 180 TH Mode D'emploi page 13

1 actual temperature
2 set temperature
3 set key (menu selection)
4 decrease values
5 increase values
6 heating control lamp (C1)
With the program controller settings are possible from a slow heating-up phase (menu - GrAd
-) to a freely selectable drying temperature (menu - set 1 -). When the drying temperature has
been reached, the controller heats up the kiln to the final temperature (menu - set 2 -) at the
maximum heating-up rate. The firing temperature is maintained over the entire firing period
(menu - A.t ı. -). After this, the controller switches to - StoP - . The actual temperature inside
the kiln continues to be indicated.