Publicité
Les langues disponibles
Les langues disponibles
CUTTING AND C
WOLFF GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1 | Tel. +49 (0)7062-91556-0 | Fax +49 (0)7062-91556-10 | E-Mail info@wolff-tools.com |
Installation Install the table to
the cutter base with provided
screws and bolts as shown.
Then insert the handle into
the handle base as show and
tighten provided screw.
Warning: Do not put your
fingers against the sharp
edge of the blade at any time.
Internet
www.wolff-tools.de
7
Straight Cutting
Insert material between the
cutting blade and the base,
flush it with the guide bar as
shown and hold the material
then push handle down to
complete a cut.
Warning: Maintain control of
the handle. Do not allow
handle to slam back after
making a cut.
Publicité
