Buffalo GJ459 Mode D'emploi page 4

UK
Troubleshooting
Fault
The unit is not working
Bags are not sealing correctly
Technical Specification
Model Voltage
GJ459 230V 50Hz
Electrical Wiring
This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 10 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection
being required they must be readily accessible.
Probable Cause
The Unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Moisture in bag under the sealing
bar
End of bag not placed above
sealing bar
Power Current
260W 1.1A
Check the unit is plugged in
correctly and switched on
Call BUFFALO agent or qualified
technician
Replace the plug fuse
Check Power Supply
Call BUFFALO agent or qualified
technician
Ensure inside of the bag is dry and
free from moisture where it is to be
sealed
Move end of bag over sealing bar
Max Sealing
Length
305mm
-4-
Action
Dimensions
h x w x d mm
235 x 430 x 85
Weight
(kg)
2.85