Publicité
Les langues disponibles
Les langues disponibles
• The recess for the burner should be made of a heat resistant material, special profiles are available for
situations where used material does not meet this requirement.
• Make sure the material used on top, back- and sidewalls of the burner is heat resistant.
• Keep a safe distance of at least 400 mm above the bio ethanol burner and minimal 50 mm on the sides.
• In case a television is placed directly above the burner, we recommend a safety distance of at least 800 mm
Always ask your TV supplier wether your TV is suitable for hanging above a fireplace.
• After the bio ethanol burner is placed in the recess make sure the bio ethanol burner is levelled.
Dimensions built-in profile:
Built-in profile S
40 x 530 x 260 mm (hxwxd)
Built-in profile L
40 x 690 x 330 mm (hxwxd)
Built-in profile XL
40 x 920 x 260 mm (hxwxd)
The opening for the built-in profile needs to be a minimum of 5 mm smaller than the size of the profile.
The built-in profile is to be milled into the top panel of your design.
resistant adhesive.
Keep enough space in the design from the top of the built-in profile, so the warmth from the burner will not
damage the panel above.
lnstructions for building in a bio ethanol burner
A
Building in with Built-in profile
desired, this can be glued with heat
BOOMM
400MM
C
B
If
Recess built-in unit:
Built-in unit S
640 x 420 x 210 mm (hxwxd)
Built-in unit L
670 x 590 x 220 mm (hxwxd)
Built-in unit XL
486 x 922 x 217 mm (hxwxd)
Built-in unit XXL
486 x 1302 x 217 mm (hxwxd)
It is also possible to use the XL and XXL unit as a see-through option, as the back panel can be removed from
these built-in units. They also have a strip on the front side at the bottom of the unit. This provides the option
to keep the metal strip in sight or to make the edge finish at the bottom higher (see pictures below). NB then
the depth is 205mm.
The XL an XXL are also equipped with metal pipes on top. These can be used to connect a tube to a ventilation
outlet in order to lead the heat to the room. If these are not necessary or desirable in your application, they can
easily be removed.
• The recess for the bio ethanol burner should be made of a heat resistant material.
• Make sure the material used on top, back- and sidewalls of the burner is heat resistant.
• Keep a space of minimal 50 mm on bath sides of the unit. This space is to be filled with insulation wool.
• Place the built-in unit in the recess, make sure the unit is levelled.
• Mount the built-in unit on the wall by attaching screws through the holes in the side strips.
• Make sure the screws attaching the built-in unit are firmly stuck in the used material.
desired, you can cover the side strips. Keep in mind that this must be done with heat resistant material.
Special profiles for covering the side strips are also available for the models L, XL and XXL.
Building in with built-in unit
r
lnstructions for building in a bio ethanol burner with built-in unit
• If
for burner M (4120)
for burner L (5820)
for burner XL (8014)
height strip 91 mm
for burner XXL (11814)
height strip 124 mm
l
l
r
�
<Il>
----------
---------
J
�
Publicité
