Zagg Power Amp 3 Instructions page 2

INTRODUCTION
With your new Power Amp 3, you're ready to stay connected to your world on all
your adventures. Just read and follow these instructions, pop your Power Amp 3
into your pocket, purse, or bag, and go with the power to prevent your phone
battery from ever dying again. Keep these instructions for future use.
1 USB Port
LED Flashlight
Micro USB charging port
CHARGING YOUR DEVICES
Your Power Amp 3 carries enough power to give your phone at least 1+ charge
(14 hours) of additional talk time*. In addition, it allows for pass-through charging
that lets you power your devices even while it's plugged in. To keep your phone
from dying:
1. Connect the USB end of your charging cable to the outlet on the
Power Amp 3.
2. Connect the other end of your charging cable to the device you want to
charge — the Power Amp 3 will automatically begin charging it.
3. Continue on your activity until your device is charged to your liking and
then disconnect the charging cable.
4. Recharge your Power Amp 3.
*14 Hours additional talk time based on a 1800mAh battery.
CHARGING YOUR POWER AMP 3
Your Power Amp 3 comes charged and ready to go; but here's how to recharge it
when you need to:
1. Connect the included micro USB charging cable to the micro USB
port on your Power Amp 3.
2. Connect the USB end of the included cable to your preferred 5V USB
outlet. Note: Do not leave your Power Amp 3 plugged into a wall
charger for extended periods of time. Doing so will diminish its
long-term performance.
3. The LED under the flashlight will light and flash according to its
current battery level. This indicates your Power Amp 3 is charging.
4. Wait for the battery indicator lights to turn off, indicating your Power
Amp 3 is fully charged.
5. Disconnect the charging cable and enjoy 3000mAh of simple,
portable power.