Publicité
Les langues disponibles
Les langues disponibles
G
B
channel A
PROGRAMMING
Turn on power supply in order to proceed with codes programming.
a - Press programming button on S433 radio receiver or on RIB CRX control panel, to
activate the learning procedure.
b - You have 10 seconds to digit the code (from 4 to 9 digits) and press one of the 2
channels (A or B) (es. 1234A).
c - End the learning procedure pressing button on the radio receiver or, wait 10 seconds
so procedure ends by itself.
ADD NEW CODES
The number of codes stored depends on the capacity of the receiver's memory.
- Repeat point "b" to add new codes.
- After 10 seconds without inserction of new codes the radio receiver
procedure by itself and the system becomes active.
NOTE: to use different radio signals from channels A and B, during programming, you
simply insert in front of the code to store the number 0, for example:
- To output a signal with channel C type 01234A
PROGRAMMING RADIO KEYPAD WITH RECEIVERS S433
channel B
RIB CRX control panels
with built-in radio receiver
single channel with connector for RIB control panels
double channel with connector for RIB control panels
double channel with connector for RIB control panels
- To output a signal with channel D type 01234B.
For the quantity of codes to be stored refer to the receiver or control panels RIB manuals.
The wireless keypad is backlit.
It turns on by pressing any key, then one can proceed to digit the code.
As long as the keyboard is lit, new impulses can be sent simply by pressing the
single key of the channel previously used.
The switch off is automatic 2 seconds after the last key is pressed.
ends learning
12
S433 1CH code ACG5081
S433 2CH code ACG5083
S433 4CH code ACG5085
S433 1CH code ACG5082
1-channel with terminal block
S433 2CH code ACG5084
2-channels with terminal block
S433 4CH code ACG5086
4-channels with terminal block
SPARK S433 2CH code ACG7063
2-channels with terminal block
Publicité
