Switching The Dimmer Setting; Setting The Rear Output And Subwoofer Controller - Pioneer DEH-P560MP Instructions D'utilisation

Initial Settings
1 Press FUNCTION to select AUX.
Press FUNCTION repeatedly until AUX ap-
pears in the display.
2 Press a or b to turn AUX on or off.
Pressing a or b will turn AUX on or off and
that status will be displayed (e.g.,
AUX :ON).

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the cars headlights are turned on. You
can turn dimmer on or off.
1 Press FUNCTION to select DIMMR.
Press FUNCTION repeatedly until DIMMR ap-
pears in the display.
2 Press a or b to turn DIMMR on or off.
Pressing a or b will turn DIMMR on or off
and that status will be displayed (e.g.,
DIMMR :ON).
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (R-SP :FUL) or subwoofer
(R-SP :S/W) connection. If you switch the rear
output setting to the R-SP :S/W, you can con-
nect a rear speaker lead directly to a subwoo-
fer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (R-SP :FUL). When rear output
are connected to full range speakers (when
R-SP :FUL is selected), you can connect the
RCA subwoofer output to a subwoofer. In this
case, you can select whether to use the sub-
woofer controllers (low pass filter, phase)
built-in P/O :S/W or the auxiliary P/O :FUL.
1 Press FUNCTION to select R-SP.
Press FUNCTION repeatedly until R-SP ap-
pears in the display.
2 Press a or b to switch the rear output
setting.
Pressing a or b will switch between
R-SP :FUL (full-range speaker) and R-SP :S/W
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select R-SP :FUL.
# When a subwoofer is connected to the rear
output, set for subwoofer R-SP :S/W.
# When the rear output setting is R-SP :S/W,
you cannot change the subwoofer controller.
3 Press c or d to switch the subwoofer
output or non fading output.
Pressing c or d will switch between P/O :S/W
and P/O :FUL and that status will be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the non fading output
(refer to Using non fading output on page 38)
or subwoofer output (refer to Using subwoofer
output on page 37) in the audio menu on.
! If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
! Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
Section
09
41
En