English - Kenwood WF97 Manuel

safety
Always treat the filtered water as a
"food stuff" and follow the hygiene
guidelines below:
Always wash your hands before
handling the unwrapped filter
cartridges, especially if you have
been preparing raw food such as
meat or poultry.
Consume filtered water immediately
or store in a refrigerator. Discard any
unused filtered water after 24 hours.
The filter is for treating mains tap
water only. Do not filter hot or boiling
water.
Wash the jug, lid and hopper
regularly, at least every time you
change the cartridge.
For best results the filter cartridge
should be kept in contact with the
water. If the filter has not been used
for 48 hours, flush the cartridge
through by filling the hopper twice
and discarding the water.
During prolonged period of non use
(eg holiday), any unwrapped or
partly-used cartridges should be
stored in the refrigerator - ideally still
inserted in the water hopper. The
cartridge once removed from the
wrapper must under all circumstances
be discarded after 30 days even if it
has not been used.
Filtered water should be boiled for
babies and young children - just as
you would boil tap water and many
types of bottled water before giving
them to your baby.
Always check the date code on the
cartridge wrapper. If passed the use
by date, discard.
Always change the cartridge every
30 days or every 150 litres -
whichever is sooner.
The filter should be kept out of direct
sunlight and away from other heat
sources.
Do not store the cartridges next to
household chemicals or cleaning
products.

English

In the event of your water supplier
issuing a "boil notice" (or similar
emergency indicating that your water
supply may be temporarily unsafe)
the filter system should not be used,
and any cartridge in use should be
disposed of.
to use your water filter
1 Remove lid and hopper completely
from jug. Wash hopper and jug
thoroughly in warm water, then dry.
Wipe the lid with a damp cloth, then
dry. Do not immerse the lid in
water.
2 Remove wrapper and immerse
cartridge in cold water for 10 minutes.
3 Insert the cartridge into the hopper
and press gently to seal.
4 Fill the hopper from the tap and
allow the water to filter. Discard the
filtered water. Do this twice.
On occasions when using a new
cartridge the first few litres of water
can appear to be tinted blue/black.
This colour is due to a small amount
of carbon dust being flushed out of
the cartridge, this is not harmful as
the carbon is food grade and will
usually disappear if the cartridge is
flushed through a couple of times.
This will not affect the performance
of the cartridge.
5 Fit the lid onto the jug. Press and
hold down the re-set/on button until
'150' appears on the display. This
indicates the number of litres of
water that the cartridge can filter.
important - when pressing the
re-set/on button the water fill
cover
6 Your Kenwood water filter is now
ready to use. Turn the knob
clockwise to fill.
7 After filling turn the knob anti-
clockwise. The display will
automatically count down on each
use.
2
must be closed.