Replace The Guard; Technical Data; Limited Warranty - GreenWorks AGG302 Manuel D'opérateur

8.2

REPLACE THE GUARD

WARNING
Do not change or loosen guard screw. Failure to follow
this warning can make the guard to become loose
during operation and cause injury.
After extended use, you must replace the guard. If you
fall the machine and cause damage the guard. It is also
necessary for you to replace the guard.
WARNING
To prevent loss of control and possible injury, operate
the machine with two hands and keep one hand on
the auxiliary handle.
• Remove the battery pack from the machine.
• Push the spindle lock.
• Use a wrench to loosen and remove clamp nut.
• Remove grinding wheel and disc flange.
• Pull the guard clasp to unlock the guard.
• Remove the guard from the groove in the housing.
• Put the new guard on the shoulder of the bearing
cap.
• Adjust the guard to the correct position.
NOTE
Make sure you install the ridge on the guard in the
groove on the bearing cap.
• Install disc flange, grinding wheel, and clamp nut.
• Tighten the clamp nut.
9

TECHNICAL DATA

Rated Voltage
No Load Speed
Shaft
Disc diameter
Weight (without battery)
Battery model
Charger model
10

LIMITED WARRANTY

YEAR/ANS/AÑOS
TOOL WARRANTY
GARANTIE DE
L'OUTIL
HERRAMIENTA
English
24 V
7000 rpm
5/8''
4 1/2''
3.53 lbs (1.6 kg)
BAM706
CAM803
®
Greenworks hereby warranties this product, to the
original purchaser with proof of purchase, for a period of
four (4) years against defects in materials, parts or
workmanship. Greenworks
repair or replace any and all parts found to be defective,
through normal use, free of charge to the customer.
This warranty is valid only for units which have been
used for personal use that have not been hired or
rented for industrial/commercial use, and that have
been maintained in accordance with the instructions in
the owners' manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
1. Any part that has become inoperative due to
misuse, commercial use, abuse, neglect, accident,
improper maintenance, or alteration; or
2. The unit, if it has not been operated and/or
maintained in accordance with the owner's manual;
or
3. Normal wear, except as noted below;
4. Routine maintenance items such as lubricants,
blade sharpening;
5. Normal deterioration of the exterior finish due to use
or exposure.
HELPLINE:
Warranty service is available by calling our toll-free
helpline, at 1-833-493-5483.
TRANSPORTATION CHARGES:
Transportation charges for the movement of any power
equipment unit or attachment are the responsibility of
the purchaser. It is the purchaser's responsibility to pay
transportation charges for any part submitted for
replacement under this warranty unless such return is
requested in writing by Greenworks
9
®
, at its own discretion will
®
.
EN