Publicité
JOB200-tmanual-fev2
12/14/06
9:02 AM
Page 7
Important Safety Information
1. READ ALL INSTRUCTIONS CAREFULLY AND BE SURE THEY ARE FULLY UNDERSTOOD BEFORE USING THE GARDEN CART.
2. Do not load the Garden Cart with more than 600 lb (272 kg). Do not use the dumping feature of the Garden Cart with a load
of more than 300 lb (136 kg). The weight rating is based on an evenly distributed load.
3. Do not allow children to use the Garden Cart without supervision. It is not a toy.
4. Do not use the Garden Cart for transporting passengers.
5. The Garden Cart is not intended for highway use.
6. Distribute the load evenly over the surface of the tray.
7. Do not load items on the top edges of the tray.
8. If any parts become damaged, broken, or misplaced, do not use the Garden Cart until the parts have been
repaired or replaced.
9. Do not use the Garden Cart on surfaces or for transporting objects that can cause damage to the pneumatic tires or tubes.
Do not inflate the tires to more than 30 PSI (2.07 BAR).
10. It is recommended that the cart be inspected for damage before each use.
11. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Assembly Instructions
Verify that all parts and hardware are accounted for before beginning assembly. Do not assemble or use the Garden Cart if
any parts are missing or damaged.
Tools required for assembly: • Standard screwdriver • Phillips screwdriver • Socket set (or two adjustable wrenches).
Step 1
Locate the rear axle assembly, as shown below.
Step 2
Attach the rear axle assembly and the rear axle
support bar to the tray using two M8 x 40 truss head
bolts, two M8 lock nuts, and two washers. Attach the
left and right rear struts to the tray using four M8 x 20
truss head bolts, four M8 lock nuts, and four washers,
as shown below.
Step 3
Attach the lock to the tray
using four M8 x 20 truss
head bolts, four M8 lock
nuts, and four washers,
as shown.
Step 4
Attach the front axle assembly to the
front frame using two M8 x 40 Phillips
flat head bolts, two M8 lock nuts, and
two washers. Attach the front axle
support arm to the frame using two
M8 x 20 hex head bolts, two M8 lock
nuts, and two washers, as shown.
Step 5
Attach the rear axle assembly to the tray using two M8 x
20 truss head bolts, two M8 lock nuts, and two washers,
as shown below.
Publicité
