Master-Slave Mode; Switching The Display On Or Off; Changing Display Alignment - MC Crypt DL-1006 Notice D'emploi

10. Operation
f) Master-Slave Mode
• Push the button FUNC until SLNd is displayed and push the button ENTER.
• Select the NASt with the arrow buttons to define the effect light as master device (control via the integrated control-
ler).
• Select SLAv with the arrow buttons to control the effect light in slave mode (control via the controller of the connected
master device).
• Confirm your selection again with ENTER.
If the device is to be operated as a single device (stand alone), it must be defined as a master device.
Only one device in a master-slave-chain must be defined as master device. All other devices must be
defined as slave devices.
g) Switching the Display On or Off
• Push the button FUNC until the Led is displayed.
• Select on with the arrows to activate the display permanently or oFF to activate the display only for programming. In
this case, the display can be activated using the button FUNC.
• Confirm your selection again with ENTER.
h) Changing Display Alignment
• Push the button FUNC until dISP or dSIP is displayed.
• Select the desired display orientation with the arrows (dISP = regular display / dSIP = display turned by 180°).
Reversal of the display is used for adjusting the display when the device is installed hanging or standing.
• Confirm your selection again with ENTER.
30