Nivelco NIVOTRACK M-500 Mode D'emploi page 20

A, Calculated value of the output current. After the dimension, the mode of current output is indicated by
inverse inscription:
Manual mode (see: chapter 5.3.2.1 )
HART address is not 0, so output current has become overwritten to 4mA (see: chapter 5.3.2.1)
Analogue transmission reacts to a programmed failure condition if an upper or lower fault current is
programmed (see: chapter 5.3.2.4 )
B, Output range (4...20mA) indicated in a bargraph.
C, Indication of Menu Lock:
If key symbol is visible, the unit is protected with a password. When entering the menu, the
instrument asks for the correct password.
If REM message is visible, the instrument is in remote programming mode and the menu
cannot be accessed.
Errors occurred during the measurement can be seen at the bottom line of the display.
20 / 36 mba5052i0600p_06 ♦ BKI16ATEX0012X ♦ IEC Ex BKI 12.0002♦ FM16US0068X♦ FM16CA0037X