DreamGEAR Power Base Dual Mode D'emploi

PACKAGE CONTENTS:
• Wireless Charging Power Base
• 2 Rechargeable Batteries
• 110/240V AC adapter
• User's Guide/Warranty Card
• Registration Card
TO CHARGE THE BATTERY WHILE ATTACHED TO WII REMOTE:
1. Insert Rechargeable Battery into the Wii Remote by sliding the top teeth
into the holes at the top of the battery compartment.
2. Press on the bottom of the battery to snap the battery into place.
3. Lay the Power Base on any flat surface.
4. Plug one end of the AC adapter into a wall outlet.
5. Plug the other end of the AC adapter into the back of the Wireless
Charging Power Base.
6. Press the ON button on the front of the Power Base.
7. Place the Wii Remote with the battery attached on one of the 2
designated slots with the directional button on the Wii Remote towards
the top of the Power Base.
8. The LED in front should be RED when charging and BLUE when fully
charged.
NOTE: You can place up to 2 Wii Remotes with batteries attached on the
Power Base at the same time. You can also leave the Wii Remote Jackets
on the Wii Remotes while charging.
TO CHARGE THE RECHARGEABLE BATTERY BY ITSELF:
1. Lay the Power Base on any flat surface.
2. Plug one end of the AC adapter into a wall outlet.
3. Plug the other end of the AC adapter into the back of the Wireless
Charging Power Base.
4. Press the ON button on the front of the Power Base.
5. Place up to 2 batteries onto the Power Base with the teeth of battery
towards the top of the Power Base.
6. The LED in front should be RED when charging and BLUE when fully
charged.
NOTE: You can place up to 2 Rechargeable Batteries on the Power Base at
the same time.
NOTE: The Wireless Power Base is ONLY compatible with dreamGEAR
"Power Base" rechargeable battery packs.