Publicité
Les langues disponibles
Les langues disponibles
Maximum weight per shelf
Model
NGF-054-H
NGF-122-H
NGF-200-H
Installation
After unpacking, check the cabinet for any damage caused during transportation. In the event of
damage, please contact the freight company immediately.
Allow the unit to stand upright for at least 1 hour prior to connection to the main electrical
supply. This gives the oil time to run back to the compressor after transit and installation.
Always ensure that your freezer is installed on level floor.
Main connection: If the main cord supplied is not long enough, do not use an extension cord.
Ask a technician to install a socket near the refrigerator.
Ensure that there is enough space between the back side of the freezer and the wall, and that
nothing is placed on top of the freezer. Allow a minimum gap of 100mm at the rear and 50mm at
the sides of the cooler.
Connection to the main supply
Connect the freezer to a 115 Volts, 60Hz power supply on a min 30A fused & grounded socket.
Do not use extension cables. If the power cord is not long enough, ask an authorized electrician
to replace it with a longer one, or to install a socket near the freezer.
Do not compress the main cable.
General user information
The electrical temperature controller is located at the top left corner of the front grille. The
controller is factory set to approx. -25°C. If you require a higher temperature (warmer) or a lower
temperature (colder), please follow the steps below:
1.
Press SET button for 1 second, the set value will start flashing after a few moments
2.
Increase or decrease the value using UP or DOWN button
3.
Press SET to confirm the new value
Max Weight / Shelf
~50kg/sh
4
Publicité
