DOREL Living DA8304E-1 Mode D'emploi page 11

FULL / FULL BUNK BED
DA8304E / DA8304GR / DA8304BK
STEP 4
Attach the support posts (W) to bottom slats (Y) with hex socket head bolts (9) as shown.
Attach bottom slats (X & Y) as shown below to bottom side rails (J & K) with flat head wood screws (4)
using a Phillips head screw driver (not included).
Make sure the slat touches the corner posts (as close to the headboard as possible).
Use space block (A1) to space them out evenly as shown.
NOTE: If you notice that any of the slats (X & Y) are not perfectly flat, be sure to assemble them so that
the slats (X & Y) curves up in the middle and down on the ends.