EAZYRC PATRIOT Manuel D'utilisation page 2

Setting the Gear Mesh
The gear mesh is the clearance between the pinion and spur
gears in your vehicle. If the motor or gearing components are
replaced,check that the gears are not meshing too tightly as
this may cause premature wear.
Charging the Battery
1.Connect the charger to a USB port then connect the battery to the charger.
2.When charging,the Green LED is flash, when charged, the Green LED is stable.
3.Do not let the battery charge unattended!
4. If the battery or charger is hot,disconnect the battery and charger immediately as this may be caused
by an internal short-circuit.
2. Connect the battery to the charger.
Lithium Polymer (LiPo) Battery Warning
●Never charge a lithium polymer battery with a charger designed for Nicd, NIMH, or any other type of battery
chemistry.Use ONLY charger designed for LiPo battery.
●Do not leave LiPo battery unattended during charging.
Do not overcharge the battery.
●Always charge LiPo batteries on non-flammable, heat-resistant surfaces.
●Always use a LiPo-safe bag or container while charging. Do not allow LiPo cells to overheat at any time.Cells
which reach greater than 140 Fahrenheit(60°C) will usually become damaged and will catch fire.
●Do not charge the LiPo pack while it is still in the model. Never charge or store battery packs in a vehicle.
●Do not discharge LiPo; doing so will damage the battery.
●Do not expose LiPo cell to water or moisture at any time.
●Do not store battery near open flame or heater.
●Do not assemble LiPo cells or pre -assembled packs together with other LiPo cells or packs.
●Always store LiPo battery in a secure location away from children.
●Always remove the LiPo battery if model is involved in any kind of crash.
●Carefully inspect the battery and connectors for even the smallest damage.
●CAUTION:Cells may become hot after usage.Allow the pack to cool to room temperature prior to recharging.
●Do not allow the electrolyte to get into eyes or on skin.Wash affected areas immediately if they if they come
into contact with electrolyte.Do not alter or modifv connectors or wires of a LiPo battery pack.
●Always inspect the condition of the battery before charging and operating.
●Do not short circuit the LiPo battery.
●Do not have contact with a leaky/damaged battery directly.
●Do not charge battery out of recommended temperature range(O°C 45°C).
1. Connect the charger's USB port to a power source.
Spare parts list
Declaration of Conformity (DoC)
declare under our responsibility that the product:
Type of Equipment: Patriot Driving System & 2.4GHz Control System
Brand Name: EAZYRC
Equipment Model: EZY001RTR
to which this declaration relates is in conformity with the essential requirements and other relevant requirements of the
RED Directive 2014/53/EU, EMC Directive 2014/30/EU,FCC Indentifier 2AUBX-TX01Z and EU RoHS Directive 2011/65/EU.
The product is in conformity with following standards and/or other normative documents:
ETSI EN 301 489-1 V2.2.3 (2019)
ETSI EN 301 489-17 V3.2.4 (2020-09)
EN 55032:2015
EN 55035:2017
EN
EN 61000-3-2:2014
SERVO
BATTERY
MOTOR
EN 61000-3-3:2013
IEC/EN62368-1
EN 62368-1:2014+A11:2017
EN 62479:2010
EN 300 328 V2.2.2:2019-07
Lipo
PCB
NIMH
BIND
EN