Publicité
Les langues disponibles
Les langues disponibles
EN – Manufacturer note
Intended use
The x-net C12 tacker tool is only suitable for attaching the
x-net pipe systems 14 x 2, 16 x 2 and 17 x 2 mm using
x-net C12 pipe anchors to the x-net C12 tacker areas. Any
other use is considered improper and therefore impermis-
sible! Modifications to the x-net C12 tacker tool and its
components are only allowed after consultation with the
manufacturer!
The manufacturer assumes no liability in the event of
improper use of the x-net tacker tool, failure to follow
the operating instructions and any damage arising as a
result.
NOTE
Keep the installation and operating instructions for
future use!
Qualification of staff
►
Only properly trained personnel are allowed to operate
the x-net C12 tacker tool.
►
Personnel undergoing training are allowed to work
with the x-net C12 tacker tool only under the supervi-
sion of an experienced installer.
Safety instructions
►
It is absolutely imperative to observe notes as to how
to hold the tacker tool properly, maintain it, etc.
CAUTION
Risk of injury!
Always wear suitable safety shoes!
►
EN - Operating instructions
The x-net tacker tool needs to be protected from dirt and
moisture!
1
Components
1
Handle
2
Spring
3
Slider
4
Inspection flap
5
Magazine rod with parked weight
6
Magazine rod
7
Adjustable foot
2
Push x-net C12 pipe anchor magazine onto the magazine
rod.
3
After loading the magazine rod, the weight is placed on
the x-net C12 pipe anchor magazine.
4
During the tacker process, the x-net tacker tool must al-
ways be held at right angles over the pipe!
NOTICE
►
If the x-net C12 tacker tool is held at a different
angle, this may cause it to malfunction!
►
Maintenance-free!
►
Do not use any lubricants!
3
Publicité
