Publicité
Assembly
• Attach lanyard to tote tank and to orange 3" cap. Attach cap to tank sewer
hose connection.
• Attach two lanyards to tote tank and one to each of the two small black caps.
Attach both small caps to the tote tank for rinse and flush connections.
• Attach the 4-in-1 elbow adapter to the end of the clear elbow and turn to
lock in place.
Holding Tank Hookup
• Remove 3" storage cap from tote tank sewer hose connection.
• Remove small hose cap from rinse connection. This will allow tank to vent
while filling.
• Connect the double bayonet clear elbow adapter to the lug fitting end of the
sewer hose and then to the sewer hose connection of the tote tank (FIGURE 1)
• Connect the other end of the hose to the RV waste water connection.
• Open the RV gate valve.
Warning: take care to not overfill tote tank
Towing
• Remove the sewer hose from RV and from the tote tank. Install and tighten
all tank caps.
• Put the tow handle in place on the tank handle. Place tow bracket loop over
ball hitch or pull by hand with the tow handle (FIGURE 2)
• Tow very slowly to the approved dump station. Take the sewer hose with you.
• Do not tow tank in excess of 5 mph
Emptying
• Insert the 4-in-1 adapter into the dump station.
• Connect the clear elbow (with 4-in-1 adapter attached) to the sewer hose.
• Connect the other end of the sewer hose to the sewer hose connection of the
tote tank (FIGURE 3A)
• Vent tote tank by removing cap from rinse connection.
• Lift the tote tank up by the handle to dump (FIGURE 3B)
Cleaning
Attach a standard garden water hose to a water supply and then select one of
the following options:
• Option 1: Remove flusher cap and connect the other end of the garden hose
to the flusher on the tote tank. This valve enables the water to spray into the
tank and is a back flow preventer. This allows for more spray with less mess.
Rinse tank thoroughly and tip the tote tank to empty (FIGURE 4A)
• Option 2: Remove rinse connection cap. Connect the other end of the garden
hose to the water hose adapter and connect the other end of the filler hose
to the rinse connection on the tote tank. Rinse tank thoroughly and tip the
tote tank to empty (FIGURE 4B)
Ladder Storage
• Ensure tank is empty.
• Hang the ladder hook of tote tank over the RV ladder rung.
• Strap the tank securely onto the ladder using notches on sides of the tank
(FIGURE 5)
• Failure to follow these warnings may result in serious injury.
FIGURE 3A
FIGURE 4A
FIGURE 4B
1
FIGURE 1
FIGURE 2
FIGURE 3B
FIGURE 5
Publicité
