Audizio SB90 Manuel D'instructions page 6

10. ARC
Press to change to HDMI (ARC) input mode directly.
11. COAX
Press to change to coaxial input mode directly.
12. BT
Press to change to BT input mode directly.
13. Repeat
Press to repeat a single track. Press again to repeat all tracks. Press again to cancel repeat.
14. Mode
Press to switch modes. Cycle through line, optical, coaxial, BT, USB and HDMI (ARC).
1. Ensure that the files stored on the flash drive are in MP3 format.
2. Insert the USB flash drive in the designated USB slot on the back of the device.
3. Press the mode key repeatedly until USB mode has been reached.
4. Use the operational buttons (volume, play/pause, etc.) on the device or remote to control the playback.
An HDMI (ARC) cable is needed (not included).
1. Connect one end of the HDMI(ARC) connecting cable to the HDMI output of the source device and the other end to the
HDMI input of the soundbar.
2. Press the mode key repeatedly until HDMI mode has been reached or press the ARC button on the remote to directly
initiate HDMI mode (the LED indicator will show "Hd").
3. Make sure the source audio is set to HDMI settings.
4. Use the operational buttons (volume, play/pause, etc.) on the device or remote to control the playback.
A 3.5mm audio connecting cable is needed (included).
1. Connect one end of the 3.5mm connecting cable to the line output (AUX) of the source device and the other end to the
line input (AUX) of the soundbar.
2. Press the mode key repeatedly until line mode has been reached (the LED indicator will show "LINE").
3. Use the operational buttons (volume, play/pause, etc.) on the device or remote to control the playback.
An optical- or coaxial connecting cable is needed (optical is included).
1. Connect one end of the optical or coaxial connecting cable to the according output of the source device and the other end
to the according input of the soundbar.
2. Press the mode key repeatedly until the optical or coaxial mode has been reached or press the OPT or COAX button on the
remote to directly initiate the desired mode (the LED indicator will show "OPt" or "COA", depending on the chosen mode).
3. Make sure the source audio is set to OPT or COA settings.
Use the operational buttons (volume, play/pause, etc.) on the device or remote to control the playback.
1. Press the mode key repeatedly until BT mode has been reached or press the BT button on the remote to directly initiate
BT mode (the LED indicator will blink "bt" in red color).
2. Turn on the BT function on your source device and search for "SB90" to pair. When the pairing has been successful, the
soundbar will emit a sound to indicate the successful pairing.
3. Use the operational buttons (volume, play/pause, etc.) on the device or remote to control the playback.
6