Charge The Powerpacks - MONNET HeatProtech Mode D'emploi

Charge the INUHEAT PowerPacks
Attach the 2 PowerPacks to the USB charger adapter. Connect the
USB charger adapter to a USB power supply (not supplied).
after they are fully charged, but best to remove them from the charger
after charging is complete
LED Charging
Status
Charging
Charged
Attach the INUHEAT PowerPacks
When the socks are on your feet, attach each PowerPack to the
connector at the top of the socks.
Fold the top cuff of the sock over the PowerPack to hold it firmly in
place.
- 22 -
With a USB power supply with
a power of 3 amps, the normal
charging time is about 2 ½
hours, with 80% of the total
charge reached in just over
1 ½ hours. It is safe to leave
the PowerPacks on the charger
Led
Manual use
Turn on the PowerPacks by pressing their button
once. When the PowerPack turns on, it vibrates
once and a green LED flashes.
Set the heating level
• Attach the PowerPacks to the socks.
• In manual mode, you have 3 heating levels
(Low, Medium and High) and a pause mode. The heating levels
operate in a loop.
• The first press of the button turns on the PowerPack and switches
to the Pause position (green flashing LED + 1 vibration).
• Pressing the PowerPack a second time changes to the Low heat
level (purple flashing LED + 1 vibration).
• A third press switches to the Medium heating level (double purple
flashing LED + 2 vibrations).
• A fourth press switches to the High heating level (triple purple
flashing LED + 3 vibrations).
• And finally a fifth press completes the loop and returns the
PowerPack to Pause mode (LED flashing green + 1 long vibration).
To turn off the PowerPack,
press the button for 3 seconds.
It will vibrate twice (a long
vibration then a short one) and
the LED will go out.
LED Operating Patterns
Manual use
Heat Led Color
0 Green
1 Purple
2 Purple
3 Purple
- 23 -
LOW
OFF PAUSE MEDIUM
HIGH
Flashes Vibrations
- (long)
- (short)
-- (short)
--- (short)