Publicité
Les langues disponibles
Les langues disponibles
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from the box.
Make sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product .
If any parts are damaged or missing, please call our customer
service help line at 1-800-313-5111 for assistance.
PACKING LIST
- Blower / Vac
- Blower Tube
- Vac Tube
- Collection Bag
- Operator's manual
WARNING: If any parts are damaged or missing do not operate
this product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING: Do not attempt to modify this product or create
accessories not recommended for use with this product .Any
such alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal injury.
WARNING: Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental starting
and possible serious personal injury.
CORD RETAINER
A cord retainer is incorporated into
the rear of the power head.
If using more than one extension
cord, first tie the two cords in a
knot as shown.
Then, double the extension cord
several inches from the end and
hook the loop formed by doubling
the cord over the retainer post as
shown.
ASSEMBLING THE UNIT AS A BLOWER
Connect the two blower tubes together.
Fit the larger diameter end of blower tubes onto the air outlet of
the motor housing.
Ensure the inlet cover is securely fastened over the air inlet
before using blower function.
INLET COVER
ASSEMBLY
CORD RETAINER
ASSEMBLING THE UNIT AS A VACUUM
Push the lower vacuum tube firmly into the upper tube until they are
locked firmly together. Once the vacuum tubes are connected, they
should never be disassembled again.
Remove the inlet cover from the bottom of the motor housing by
depressing the lock button and pulling the cover downward.
Attach the vacuum tube assembly to the motor housing by positioning
the assembly as indicated by arrow, then pivot about this point until
the locking/release catch is fully engaged.
Attach the push-on collection bag connector to the outlet tube of the
housing. Push the fitting of the collection bag directly onto the outlet
until it "clicks" into position.
BLOWER TUBES
VACUUM TUBES
COLLECTION BAG
4
Publicité
