Wireless Set-Up - FireAngel RLYM-1 Mode D'emploi

DO NOT:
• Exceed the maximum of 50 alarms/devices
interlinked in a network.
• Connect FireAngel alarms to any models produced
by another manufacturer.

WIRELESS SET-UP

How to 'learn-in' a wireless device to the relay:
Install relay unit as described earlier (see
'Installation'). Install the smoke, heat or CO alarm in
its appropriate location.
1. Using a ballpoint pen briefly push and release the
'learn button' marked "LRN" on the front section
of the relay. The 'learn' LED will illuminate "Blue"
once for 5 seconds.
2. While the LED is on, briefly press the test button
on any alarm to wirelessly interlink the two. The
alarm will give an audible sound consisting of
two cycles of three loud beeps.
3. The "Blue" 'learn' LED of the relay unit will flash
repeatedly to indicate that it has been
'learned-in' successfully. If the test button is not
pressed quickly enough, the 'learn-in' process
will fail. If this happens, repeat the process.
Your relay unit counts as one unit within the network.
The network cannot exceed 50 units in size including
the relay unit.
To complete the installation, fit the relay unit cover
using the screws provided.
9