DCOOK GALLERY 8102001 Notice D'utilisation page 37

• Cover the jug with the lid
• Connect the blender to a properly installed socket.
• To start the blending process, raise the speed control
slowly, until you reach the required speed.
• To stop blending, turn the speed control to level "0".
• Wait until the blades have stopped completely before
removing the safety lid.
E/ Refilling ingredients
• Other ingredients can be added during the blending
process.
• Remove the filling hole lid, by exerting slight pressure
upwards and add the ingredients through the filling hole.
F/ Crushing ice cubes
1. Fill the blender jug with ice cubes. Do not crush more than
10 to 12 ice cubes at the same time.
2. Make sure that the ice cube is no longer than 2.5 cm. You
get better results by crushing a few ice cubes at a time.
3. Close the blender jug with the lid and the lid accessory (see
the "Assembly of the blender" section).
4. Set the speed control to level "0" and connect the blender
to a properly installed socket.
5. Press the PULSE button several times for a short period of
time and release it again, until you obtain the required ice.
CLEANING
• Inappropriate use of the blender can cause
electric shock. Water in the casing can cause
a short-circuit.
37