Bracket Installation For On-Wall Speakers (Pictorial) - Paradigm Reference OM-1000 Mode D'emploi

BRACKET INSTALLATION FOR ON-WALL SPEAKERS (pictorial)

IMPORTANT NOTES: Please read before installing brackets
Paradigm DOES NOT supply hardware for mounting brackets to the wall. Mounting hardware shown
is an example only; hardware will vary depending on wall type.
If installing in drywall, thickness should be 1/2˝ (13 mm) or 5/8˝ (16 mm) only. Screws must be long
enough to go through anchor bolts and firmly into drywall (see Inset 1).
A specific clearance is required when sliding on-wall speakers onto bracket. For more information
see Fig. 8g.
• 5 – Anchor bolts (minimum load rate 25 lb / 11.3 kg) • 5 – Flathead (Countersunk) screws. (TIP: Paint to match Black speaker finish)
(Note position of metal tab)
Fig. 8a
Position bracket for horizontal or vertical (see
Inset 2) placement and mark center hole. Press
anchor bolt firmly into drywall and screw in. Follow
with flathead screw (see 'WARNING!' at right) .
Fig. 8b
Ensure bracket is level, then mark the holes for
anchor bolts.
8
PARTS INCLUDED (ONE SPEAKER):
• 1 – Wall-mounting bracket • 1 – Angle bracket with 2 screws • 1 – Hex key
REQUIRED, NOT INCLUDED (ONE SPEAKER):
WARNING! Screws must be inserted straight and
fully tightened to ensure correct operation of bolts.
Fig. 8c
Allow bracket to rotate clockwise, then screw in
anchor bolts.
Inset 1
Metal tabs must sit at outer edges (as shown) when
brackets are installed vertically.
Fig. 8d
Reposition bracket as shown. Align screw holes in
bracket over anchor bolts. Insert screws.
Inset 2