Publicité
Les langues disponibles
Les langues disponibles
LED INDICATORS
The LED Indicators will behave differently with each button on the remote control.
Function
Input
Bluetooth Pairing
DTS TruVolume
On/Off
DTS TruSurround
On/Off
Treble Levels
Bass Levels
LED Behavior
Analog Audio In - AUX (1)
Press the INPUT button on the remote to cycle through each available input:
Analog Audio In - AUX (2)
Coaxial In - Digital (3)
Digital Optical Audio In -
Optical (4)
Bluetooth
Press and hold the
(When searching for device)
Flash from Left to Right
minutes. You can now search for the Sound Bar (VIZIO S3820w) using your Bluetooth Device.
and back continuously.
The sound bar will power down if no device is found.
Note: Set your Bluetooth device into pairing mode prior to the Sound Bar.
TruVolume On:
Press the TVOL button to enable/disable TruVolume. When enabled (On), TruVolume
provides a consistent and comfortable volume level for a more enjoyable listening
TruVolume Off:
experience.
Press the TSHD button to enable/disable DTS TruSurround. When enabled (On), all inputs will
TruSurround On:
produce virtual surround sound. When disabled (Off), all sources will playback in stereo.
TruSurround Off:
Two center LEDs indicate
Press the TREBLE button then press the Next/Previous button to increase/decrease the
Treble level 0.
treble level. The LED indicators will move to the right with increasing levels and to the left with
decreasing levels.
Press the BASS button then press the Next/Previous button to increase/decrease the bass
Two center LEDs indicate
Bass level 0.
level. The LED indicators will move to the right with increasing levels and to the left with
decreasing levels.
LED Indicators are located here:
•
Analog Audio In - AUX (1)
•
Analog Audio In - AUX (2)
•
Coaxial In- Digital (3)
•
Digital Optical Audio In - Optical (4)
•
Bluetooth
button on the remote. The Sound Bar will be discoverable for 15
Description
Publicité
