Velleman DPF1 Guide De Démarrage Rapide

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If the device was damaged in transit, don't install
or use it and contact your dealer. The DPF1 comes with: 1 x 1.5" digital photo album, 1 x key chain, 1 x USB cable, 1 x CD-ROM and this manual.
System requirements: Pentium
RAM (128 MB recommended), CD-ROM drive, USB port, 16-bit colour video card.
2. First-Time Usage
• Charging the Built-In Battery
The battery needs to be charged for approximately 4.5h prior first use. Plug the USB cable into the USB input of the DPF1 and plug the other end into the
USB port of your computer. Select "USB Charge" and press
• Turning the Unit On/Off
Press and hold to switch on. To switch off, press
selected in the menu.
• An Overview of the Controls
A
Scroll left / show previous picture
B Power on/off / confirm
C
Scroll right / show next picture
D
USB 2.0 USB input
E RESET Unit reset button
• Installing the PhotoViewer Software
Note: The unit should not be connected to the computer when installing the software.
Insert the CD into the CD-ROM of your computer. The CD will auto launch. Follow the instructions in the box and click "Finish" to complete the setup.
3. Operating the Unit
• Accessing the PhotoViewer Software
Connect the unit to your computer. Launch the PhotoViewer program. To add a picture, open the picture location folder and click the picture. Press
place the picture in the right table of the program. To delete a picture, click the picture in the right table of the program and click "X". Finally, click
"Synchronize" to save the changes.
Note: Once the PhotoViewer program is installed, the unit will not automatically be detected when connecting to the computer. To start, connect the unit
to the computer and select the "USB Update" option.
• Viewing Pictures on the Unit
Press and hold to switch on the unit. Press
the previous/next picture with / . For an automatic slideshow, select the "Auto Slide" option and press
to confirm. Press "Exit" to return to your photo album.
• Setting Date/Time
Press and hold to switch on the unit. Press
confirm. Choose the desired clock format under "Clock Disp".
DPF1
DPF1 – 1.5" DIGITAL PHOTO FRAME
® III 500 MHz or higher, PC with Windows
to enter the menu and press
to enter the menu. Select "Display Mode" and press
to enter the menu. Select "Clock Set" and press
® Me, 2000, XP or Vista / Mac
to confirm.
again to switch the unit off. The automatic on/off function can be
1
® OS 10.2.8, 100 MB free hard disk space, 64 MB
to enter. Select the "Manual Slide" option to select
to confirm. Set the speed using / . Press
to enter. Set date and time with / and press
to
to
VELLEMAN