Publicité
Les langues disponibles
Les langues disponibles
General Features
ˆ New ergonomic design
ˆ Large backlighted display, 2 lines, 16 columns
ˆ Brightness and Contrast adjustment
ˆ Backlighted keys
ˆ 3 pairs of keys for fast activation of Burglar, Fire
and Emergency alarms
ˆ 2 Tamper Switches
ˆ 1 Snatch Switch (optional)
ˆ 1 Programmable zone
ˆ Choice of Wall Anchorage
Description
The MIA-S keypad has been designed to be used
with compatible Omnia and Academy40 series Con-
trol panels.
The operating principles of the MIA-S and OmniaTAST-
R keypads are the same, barring the differences de-
scribed in this Instructions Insert. Therefore, please
review the Control panel manual to get an overall
understanding.
Installation Guidelines
Carefully work through the following steps (see Fig-
ure 1)
1. Open the flip 14.
2. Remove the screws 15.
3. Remove the frontplate 16.
4. Detach the PCB 11 from the backplate 12.
5. Insert the Snatch Switch 2 as per Figure 1 (for
keypads with Snatch Switches only).
The Snatch Switch is optional (order code ASNC).
6. Pull the connection wires through the wire entry
13.
7. Using wall anchors, secure the backplate 12 to
the wall or onto the outlet box.
8. Secure the Snatch bracket 1 to the wall (for
keypads with Snatch Switches only).
The Snatch Switch cannot be used when mount-
ing the MIA-S onto an outlet box
9. Reattach the PCB 11 to the backplate 12.
10. Connect the Snatch switch 2 to the connector 5
(for keypads with Snatch Switches).
11. Set the BPI Level, as per the relevant instructions
in the Control panel manual.
12. Assign the Address, as per the relevant instruc-
tions in the Control panel manual.
13. Complete the connections on the terminal board
10, as per the relevant instructions in the Control
panel manual.
14. Replace the Cover 16 to the backplate 12.
15. Using the screws 15 secure the Cover.
ENGLISH
Setting the BPI Level
The BPI Level of the keypad must match the BPI
Level of the Control panel (please refer to your
Control panel manual for details).
The BPI Level of Omnia and Academy40 se-
ries Control panels is 5 V.
Using jumpers 3 and 9, as per Table 1, select the
keypad BPI Level.
%3, /HYHO
-XPSHU
-XPSHU
Assigning the Address
Each keypad must occupy a different Address.
Using the DIP switches 6, as per Table 2, assign
the keypad Address.
The positions of DIP switches no. 1 and no. 2
are irrelevant.
$''5(66
7DEOH 6HWWLQJ %3, /HYHO
9
%3, 9
9
BBB
9B
7DEOH $GGUHVV 6HWWLQJV
',3 6:,7&+(6
21
21
21
21
9
%3, 9
9
BBB
9B
21
21
21
21
21
21
21
21
Publicité
