Worx FD WX270L Mode D'emploi page 14

TROUBLE SHOOTING
Problem
Battery will not charge
Switch cannot be
pressed
Driver stops during
driving screws
14
Possible cause
1. Charger not plugged into a
working outlet.
2. Surrounding air temperature is
too hot or too cold
Forward/Reverse switch at middle
position
Driver battery is out of power
Screw size is too big
Solution
1. Plug charger into a working outlet. Check
current by plugging in a lamp.
2. Move charger to an appropriate place
in which temperature is suitable for the
charger.
Press the lower half of the switch for forward
rotation. Press the upper half for reverse.
Make sure the driver is fully charged before
using it.
Ideal maximum screw size for the
ForceDriver is 6mm.