Télécharger Imprimer la page

weBoost Connect 4G-X Instructions D'installation page 11

Amplificateur de signal cellulaire
Masquer les pouces Voir aussi pour Connect 4G-X:

Publicité

Signal Booster Specifications
Model Number
Connectors
Antenna Impedance
Frequency
Passband Gain (nominal)
20 dB Bandwidth (MHz)
Typical
Maximum
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Power output for multiple
received channels (Uplink) dBm
No. Tones
Power output for multiple
received channels
(Downlinklink) dBm
No. Tones
Noise Figure
Isolation
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory
reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase
coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected.
If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn
the power off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1
minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually
restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster's
microprocessor.
The Manufacturer's rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are
present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to
adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the
device.
!
To Outside
Antenna
Lightning
Surge Protector
(sold separately)
To Signal Booster
Need help?
698-746 MHz, 746-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
700
Band12/17
700
MHz
MHz
59.1
700
Band12/17
700
MHz
MHz
28.6
33.2
700
Band12/17
700
MHz
MHz
23.2
700
Band12/17
700
MHz
MHz
-0.4
700
Band12/17
700
MHz
MHz
2
24.5
3
20.9
4
18.4
5
16.5
6
14.9
700
Band12/17
700
MHz
MHz
2
0.2
3
-3.3
4
-5.8
5
-7.7
-10.1
6
-9.3
-11.7
RECOMMENDED INSTALLING THE LIGHTNING SURGE PROTECTOR
(SOLD SEPARATELY)
INSTALL THE LIGHTNING SURGE PROTECTOR (LSP) CLOSE TO THE SIGNAL
BOOSTER. ATTACH THE CABLE FROM THE OUTSIDE ANTENNA TO THE
SURGE PROTECTOR. ENSURE THE LSP IS PROPERLY GROUNDED.
#859902-50 OHM MAY BE PURCHASED AT WWW.WILSONELECTRONICS.COM
Ground Wire
OR BY CALLING 800-204-4104.
(not included)
www.weBoost.com
Connect 4G-X
471004
N-Female
50 Ohms
Band13
800
MHz
56.2
59.2
Band13
800
MHz
27.6
38.3
33.2
40.4
Band13
800
MHz
23.8
25.2
Band13
800
MHz
-2.1
-2.0
Maximum Power
Band13
800
MHz
22.1
24.5
18.5
21.0
16.0
18.5
14.1
16.6
12.5
15.0
Maximum Power
Band13
800
MHz
-2.2
-0.8
-5.7
-4.3
-8.2
-6.8
-8.7
-10.3
5 dB nominal
> 90 dB
110-240 V AC, 50-60 Hz, 20 W
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
1700/2100
1900
MHz
MHz
64.8
67.8
1700/2100
1900
MHz
MHz
80.8
76.9
81.0
80.0
1700
1900
MHz
MHz
22.5
22.1
2100
1900
MHz
MHz
0.9
-1.4
1700
1900
MHz
MHz
22.3
21.4
18.7
17.8
16.2
15.3
14.3
13.4
12.7
11.8
2100
1900
MHz
MHz
0.7
2.1
-2.8
-1.4
-5.3
-3.9
-7.2
-5.8
-8.8
-7.4
11

Publicité

loading