Garmin GHS 20 Instructions D'installation page 5

3. Use a ⅛ in. (3 mm) drill bit to drill the
two pilot holes.
4. Use the included 25 mm M4.2 × 1.4
panhead screws to attach the GWH 20 to
the surface.
5. Route the GWH 20 cable to the
VHF 200/200i or the VHF 300/300i.
6. Perform an action:
• On a VHF 200/200i, connect the
GWH 20 cable to the microphone
relocation port on the rear of the
radio.
• On a VHF 300/300i connect the
GWH 20 to the STATION 3 port on
the radio.
The GWH 20 cannot be connected
to any other station on the
VHF 300/300i.
GHS 20/20i Installation Instructions
Pairing GHS 20/20i
Up to three GHS 20/20i handsets can be
paired with the GWH 20. You must pair
a GHS 20/20i handset with the GWH 20
only once. The device and the handset
automatically connect after they have been
paired.
1. Turn on all of the GHS 20/20i handsets
you want to pair.
2. Make sure the GWH 20 is connected to
the VHF 200/200i or VHF 300/300i radio
(page 4), and turn it on.
3. On the VHF 200/200i or on a handset
connected to the VHF 300/300i, select
MENU > COMMUNICATIONS >
PAIRING.
4. Select OK to search for the GHS 20
handsets.
A list of IDs for found GHS 20/20i
handsets is shown.
5. Select a handset ID.
6. Select ACCEPT.
A message is shown while the handset
pairs with the GWH 20.
EN-5