sentlotec QUBE Serie Instructions D'installation page 32

Instructions for installation and use
● Only install one sauna heater in the cabin. The Qube sauna
heater must not be used together with other sauna heaters in
a sauna cabin.
● The roof and walls of the sauna cabin shall be manufactured
from low-resin, untreated or thermally treated woods, e.g. Nordic
spruce, hemlock, pine or fir, or from laminated wooden materials.
If laminated wooden materials are used, make sure that the adhe-
sive does not produce formaldehyde. If other materials apart from
wood are used in the sauna cabin, these materials must be heat
and corrosion-resistant and must not have any negative effects
on the health of the sauna users.
● The height of the sauna cabin must be at least 2.0 m.
● Observe the specifications on volumes and on ventilation of the
sauna cabin in chapter 10. Technical data.
● When positioning the sauna heater, observe the minimum safety
distances (see chapter 4.2. Safety distances).
● Also observe the immediate surroundings of the installation
location.
● For your own safety, consult your supplier in the event of problems
that are not explained to a large enough extent in the installation
instructions.
WORLD OF WELLNESS
p. 6/26