Oster PRO 3000i Manuel D'instructions page 7

• The tasks described here for troubleshooting can be done mostly by the operator.
• Some tasks only may be done by specially trained personel or by an authorized
service center. These tasks are marked with (*).
MALFUNCTION
Top blade does
not move
Clipper cuts
badly or not at all
Motor is not
running
Motor runs very
slowly
Running time of
a fully charged
battery is too
short and / or
blades are getting
hot
The control light
of the charging
station in not on
When battery is
unloaded the light
does not change
from green to red
TROUBLESHOOTING
CAUSE
Clipperhead is not well engaged Engage the clipperhead correctly when the
Drive carrier is defective
Clipper blade is blunt
Clipper blades have not been
correctly ground
Clipper blades are not oiled
The animal's hair is wet
Hairs jammed between top and
bottom blades
Clipperhead has too little
clipping pressure
Battery flat
Contacts dirty
Faulty battery
Smell of burning from the motor
housing. Motor burned out.
Motor and / or electronics faulty Have motor and / or electronics replaced (*)
Clipperhead blocked
Clipper blades were not oiled
sufficiently
Clipper blades were not oiled
sufficiently
Flat, not fully charged or faulty
battery is being used
Charging station is not
connected to the power supply
Charging station is faulty
Contacts dirty
Faulty battery
Contacts of the charging station
are deformed
RECTIFICATION
motor is running
Replace drive carrier (*)
Have top and bottom blades resharpenend
by service center (*)
Oil clipper blades every 15 minutes
Only clip dry hair
Take off clipperhead, push the top blade half
away from the clipperhead, take away hairs
between top and bottom blade
Have clipperhead inspected (*)
Charge battery
Switch clipper off and clean the contacts
Replace battery (*)
Have motor and / or electronics replaced (*)
Clean and oil clipperhead
Oil clipper blades
Oil clipper blades
Only use intact, fully charged original
batteries
Connect the charging station to the power
supply
Have charging station inspected (*)
Clean contacts
Replace battery (*)
Have the charging station repaired (*)
- English-7 -