Edelbrock 2105 Instructions D'installation page 2

Masquer les pouces

page de 12

/ 12
Signets

Les langues disponibles

Manifold 2105 and 21053 (Non-Emissions) Continued:

CARBURETOR

Thunder Series #1825 (650 cfm)

Thunder Series #1826 (650 cfm)

Performer #1407 (750 cfm)

Performer #1411 (750 cfm)

Performer #1412 (800 cfm)

Performer #1413 (800 cfm

Thunder Series #1812 (800 cfm)

Thunder Series #1813 (800 cfm)

Manifold 7105, 71053, 71054, 7505, 75054 (Non-Emissions):

CARBURETOR

Performer #1407 (750 cfm)

Performer #1411 (750 cfm)

Performer #1412 (800 cfm)

Performer #1413 (800 cfm

Thunder Series #1812 (800 cfm)

Thunder Series #1813 (800 cfm)

A - Carburetor will work with non-EGR or pre-emission control systems.

B - Carburetor will work with EGR system.

H - Carburetor has provision for evaporative canister.

I - Carburetor has no provisions for evaporative canister.

K - Carburetor requires #8008 or #8024 stud, washer and nut kit. Determine proper length based on gasket thickness and your accessory

mounting requirements.

N - Carburetor accepts factory cruise control

O - Carburetor comes with manual choke. It can be converted to electric choke using kit #1478.

THROTTLE BRACKETS: Due to the design of Performer manifolds, the throttle and kickdown bracket on some vehicles may require

•

modification to fit.

•

GASKETS: Do not use competition style intake gaskets for this street manifold. Due to material deterioration over time, internal leakage of

vacuum, oil, and coolant may occur.

INTAKE MANIFOLD

2105, 21053, 7105, 71053, 7505,

75054

NOTE: To ensure maximum performance and a proper seal, Edelbrock gaskets which are

specifically designed and manufactured for use with Edelbrock parts must be used.

BEFORE INSTALLING THE INTAKE MANIFOLD: Using a 3/8" Hex (Allen) wrench, install the supplied threaded water bypass tube into the

•

front of the manifold. Make sure to use thread sealant on the threads of the water tube to prevent leaks. Test fit the intake manifold with

the bypass tube installed to make sure the bypass tube and water pump are aligned properly and have proper clearance between them. See

"Intake Manifold Test Fit Procedure" listed below for instructions.

DISTRIBUTOR AND PUSHROD INSTALLATION: Due to the close tolerance of the distributor and pushrod fit, test fit the intake manifold to

•

check for proper clearance. See "Intake Manifold Test Fit Procedure" listed below for instructions.

Rev. 5/14/13 - QT/mc

REFERENCE

PARTS REQUIRED FOR INSTALLATION

A, I, K, N