Infant Car Seat - Baby Trend Snap-N-Go GX Universal Manuel D'instruction

INFANT CAR SEAT

ATTACHING UNIVERSAL CAR SEAT
ADAPTER
WARNING:
serious injury from falling or
sliding out, always use the
Infant Car Seat harness.
CAUTION: Avoid serious
injury from falling, always
use the safety belt to secure
car seat to stroller.
• Only approved Snap Tech™ products can
be used on the stroller frame.
6) • Attach the Universal Car Seat Adapter
by lining up the anchors on the side of
the car seat adapter with the anchors
on the stroller frame and pushing them
together until they click securely
(Fig. 6a).
• Place car seat onto the adapter frame.
The car seat can face in either direction,
forward or backward (Fig 6b).
• Strap the Safety Belts through the Belt
Path on the Car Seat and connect the
buckles together (Fig 6c). Tighten the
strap so it fits snugly and the car seat is
secured to the frame. Tighten the bottom
support straps, located on the back of
the upper frame, by pulling back on the
loop and sliding the adjuster forward for
a snug fit (Fig 6d).
NOTE: The Safety Belt must be installed
through the Car Seat Belt Path before
using this product.
7
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Avoid
ATTATCHING SNAP TECH™ INFANT CAR
SEAT
WARNING:
serious injury from falling or
sliding out, always use the
Infant Car Seat harness.
Fig. 6a
• Only approved Snap Tech™ products can
be used on the frame.
7) • Attach the car seat by lining up the seat
anchors on the side of the car seat
with the anchors on the stroller frame
and push them together until they lock
securely (Fig. 7).
Fig. 6b
TO REMOVE INFANT CAR SEAT/ADAPTER
8) • To take off the infant car seat or adapter,
push both center buttons on each side of
the seat and lift the seat upwards (Fig.8).
DO NOT remove with child in the seat.
Fig. 6c
Fig. 6d
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
INFANT CAR SEAT
Avoid
Fig. 7
Fig. 8
8