AXIL AC 0536 E Manuel D'utilisation page 33

After determining the height of stand, follow the installation instructions in below
to install wall mount to different kinds of wall
Wooden wall:
Using a awl or nail to make where the nails are located, as shown as FIG 3B. Distance
between two nails for fixing wall mount must not less than 16 . Slide the plate into
position as required.(FIG 3C) Pre-drill these holes with a 5mm drill bit to at least
40mm in deep hole. Use wall mount as a template to mark the location of other three
holes and drill the same holes. Fix the wall mount to the wall with 4 long bolts(J) and
washers(L) .Please make sure these holes are level and eudipleural.
by Box wrench(6)
Brick, Concrete and Stone wall
Using a awl or nail to make where the nails are located. Distance between two nails
for fixing wall mount must not less than 40 cm . Slide the plate into position as required.
(FIG 3C) Pre-drill these holes with a 10mm drill bit to at least 50mm in deep hole. Use
wall mount as a template to mark the location of other three holes and drill the same
holes. Please make sure these holes are level and eudipleural. Insert wall anchors(K)
into each of these holes. Attach the wall mount to the wall using 4 long bolts(J) and
washers(L)by Box wrench(6).
FIG 3B
I
J
H
FIG 3D
Using balance-adjusting system on the
plate, make sure whether wall plate is
Ajuste de nivel
installed balance. If not, then slide the
wall plate let pointer level in the center
position.
6
33
Plate
FIG 3C